Washer & washing machine repair · Saanich, BC

Washer Repair Saanich

Won't drain, won't spin, leaking, loud or stuck mid-cycle.

We handle washing machine repair in homes across Saanich, front-load and top-load alike. Whether it's sitting full of water, spinning weakly, leaking under the door, banging on spin or flashing an error code, a technician comes to your laundry room, finds the fault and works on it there.

01It won't drain, or water stays in the drum

The cycle ends with clothes sitting in water. Something is stopping the water on its way out, or the pump isn't running.

  • Often
  • Clogged drain filter
  • Drain pump
  • Kinked or blocked hose
02It won't spin, or clothes come out soaked

A washer won't spin until it has drained and senses the drum is safe to turn, so a spin problem can start somewhere else entirely.

  • Often
  • Drive belt
  • Motor or motor coupling
  • Lid switch or door lock
  • Drain issue
03Water leaking onto the floor

Where the water shows up tells a lot. Under the door on a front loader usually means the seal; underneath or behind points to hoses or the pump.

  • Often
  • Door boot seal
  • Inlet or drain hose
  • Pump seal
  • Tub seal
04It won't fill, or fills very slowly

If the taps are open and water still doesn't come in, the valve that lets it into the machine or the screens inside it are the usual suspects.

  • Often
  • Water inlet valve
  • Clogged inlet screens
  • Pressure switch
05Shaking, banging or walking across the floor

Some movement on spin is normal. Loud banging, grinding or a machine that travels means the drum isn't being held steady anymore.

  • Often
  • Shock absorbers
  • Suspension springs
  • Drum bearings
  • Levelling feet
06The door won't lock, or won't open after a cycle

Front loaders lock the door for safety and won't release it while water is inside. A stuck door often comes down to the lock itself or water that hasn't drained.

  • Often
  • Door lock assembly
  • Door latch or hinge
  • Drain problem
07It won't start, or shows an error code

Error codes point the technician in the right direction. Write down the code before you call, it helps us prepare.

  • Often
  • Door switch
  • Control board
  • Sensors

Symptoms

What is your washer doing?

The problems we're called about most in Saanich laundry rooms, with the parts that usually cause them. The technician confirms the actual fault on site before any repair.

Washer brands we repair

Don't see yours? (250) 999-3866

01Samsung
02LG
03Whirlpool
04Maytag
05GE
06Frigidaire
07Electrolux
08Bosch
09Miele
10Kenmore
11Speed Queen
12Amana

Before you call, four quick checks

A few minutes in the laundry room can sometimes save a visit.

  1. 1

    Water taps

    Both taps behind the washer should be fully open. If one was turned off, the machine may not fill.

  2. 2

    Door or lid

    Close it firmly. Most washers won't start, or won't spin, unless they sense it's shut.

  3. 3

    Drain hose

    Look behind the machine for a kinked or crushed hose, especially if it was moved recently.

  4. 4

    Load balance

    One heavy item can throw the drum off. Spread the load out and try the spin again.

Still not working, or water on the floor? Turn off the taps behind the washer, don't run another cycle, and book a washer repair.

Book a repair

Book your washer repair in Saanich

Send your details and we'll call back to go over the washing machine and set up a visit. Or call (250) 999-3866.

Service requestWasher · Saanich, BC