Dryer repair · Saanich, BC

Dryer Repair Saanich

No heat, slow drying, squealing, or it just won't start.

We handle dryer repair in homes across Saanich. Whether the drum turns but the clothes stay damp, it takes two cycles to dry a load, it thumps and squeals, or it shuts off halfway through, a technician comes to your laundry room, finds the fault and works on it there.

Dryer brands we repair

Don't see yours? (250) 999-3866

01Samsung
02LG
03Whirlpool
04Maytag
05GE
06Frigidaire
07Electrolux
08Bosch
09Miele
10Kenmore
11Speed Queen
12Amana

Symptoms

What is your dryer doing?

The dryer problems we see most in Saanich homes, with the parts that usually cause them. The technician confirms the actual fault on site before any repair.

Burning smell or a dryer that's hot to the touch? Stop using it, unplug it and call us before running another load.

01It tumbles, but there's no heat

The drum turns and the timer runs, yet the clothes come out cold and damp. Something in the heating circuit has stopped working or cut out for safety.

  • Often
  • Heating element
  • Thermal fuse
  • High-limit thermostat
  • Igniter on gas models
02It takes two or three cycles to dry

Slow drying is very often an airflow problem. When damp air can't escape, the dryer runs longer and works harder than it should.

  • Often
  • Clogged vent line
  • Lint buildup
  • Cycling thermostat
  • Moisture sensor
03It hums, but the drum won't turn

You can hear the motor, yet the drum sits still. The link between the motor and the drum has usually slipped or broken.

  • Often
  • Drive belt
  • Idler pulley
  • Drive motor
04Squealing, thumping or grinding

New noises mean something that supports or turns the drum is wearing out. Catching it early usually keeps the repair simpler.

  • Often
  • Drum rollers
  • Idler pulley
  • Drum glides
  • Worn belt
05It won't start at all

No sound when you press start usually points to a switch that tells the dryer it's safe to run, or a fuse that has already blown.

  • Often
  • Door switch
  • Start switch
  • Thermal fuse
  • Control board
06It gets very hot or smells like burning

Excess heat usually means air isn't moving through the dryer the way it should. Stop using it until it's been checked.

  • Often
  • Blocked vent
  • Lint inside the cabinet
  • Cycling thermostat
07It shuts off mid-cycle or shows an error

A dryer that stops early is often protecting itself from overheating. Note any error code on the display before you call.

  • Often
  • Overheating
  • Motor
  • Sensors
  • Control board

Before you call, four quick checks

Most take less than a minute and sometimes save a visit.

  1. 1

    Lint screen

    Pull it out and clean it. A clogged screen alone can double drying time.

  2. 2

    Outside vent

    With the dryer running, check the vent outside. You should feel warm air and see the flap open.

  3. 3

    Breaker

    Electric dryers use a double breaker. If half of it trips, the drum can still turn without any heat.

  4. 4

    Cycle setting

    Make sure it isn't set to air fluff or a no-heat option, and that the load isn't too big.

Still damp or not starting? Book a dryer repair and we'll take it from there.

Book a repair

Book your dryer repair in Saanich

Send your details and we'll call back to go over the dryer and set up a visit. Or call (250) 999-3866.

Service requestDryer · Saanich, BC